Installation - Salda Ptouch Service Manual

3. Ptouch installation on a plaster-board wall:
Ptouch installation on a plaster-board wall:
1
4
7
1-2 Turn over the panel. Use a screwdriver to lift the cover as shown in fig. 2.
3 Take the cover apart.
4 Put it at desired location on the wall. The arrow must point upwards. Mark the positions of mounting
holes (distance center-to-center is 106 ± 0.5 mm). Also mark the position of the square hole for the cable
(30 x 20 mm).
5 Drill two 5 mm holes at the marked positions for nylon plugs and the hole throughout the wall to install
the cable. Insert the nylon plugs.
NOTE: You can use special metal plugs (included) instead of nylon ones.
6 Use included 2,9x16 DIN7981C screws and mount the panel to the wall as indicated in fig. 6.
Connect the included cable to the panel and pass another end of the cable through the square hole in
the wall.
7-8 Put the panel on the mounting bracket by aligning the upper identations. Then push the lower part
of the panel.
IMPORTANT: Do not forget to connect the cable before attaching the panel.
2
5
8
3
6
IMPORTANT: IT IS FORBID-
DEN to leave the remaining
remote controller's cable in
the AHU's control box!
EN
3
5