Ospf Virtual Link Settings - D-Link xStack DES-3800 Series User Manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch

OSPF Virtual Link Settings

Click the OSPF Virtual Interface Settings link to view the current OSPF Virtual Interface Settings. There are not virtual
interface settings configured by default, so the first time this table is viewed there will be not interfaces listed. To add a new OSPF
virtual interface configuration set to the table, click the Add button. A new menu appears (see below). To change an existing
configuration, click on the hyperlinked Transit Area ID for the set you want to change. The menu to modify an existing set is the
same as the menu used to add a new one. To eliminate an existing configuration, click the in the Delete column.
Figure 8- 34. OSPF Virtual Interface Settings
The status of the virtual interface appears (Up or Down) in the Status column.
Figure 8- 35. OSPF Virtual Link Settings – Add
Figure 8- 36. OSPF Virtual Link Settings - Edit
Configure the following parameters if you are adding or changing an OSPF Virtual Interface:
138