D-Link xStack DES-3800 Series User Manual page 164

Parameter
VRID / Interface
Name
Virtual IP Address
Master IP Address
Virtual Router State
State
Display
Delete
Click the Add button to display the following window to configure a VRRP interface.
Or, the user may click the hyperlinked Interface Name to view the same window:
The following parameters may be set to configure an existing or new VRRP interface.
Parameter
Interface Name
VRID (1-255)
IP Address
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
Description
VRID - Displays the virtual router ID set by the user. This will uniquely identify the VRRP
Interface on the network.
Interface Name - An IP interface name that has been enabled for VRRP. This entry must
have been previously set in the IP Interfaces table.
The IP address of the Virtual router configured on the Switch.
Displays the IP address of the Master router for the VRRP function.
Displays the current state of the Virtual Router on the Switch. Possible states include
Initialize, Master and Backup.
Displays the VRRP state of the corresponding VRRP entry.
Click the button to display the settings for this particular VRRP entry.
Click the to delete this VRRP entry.
Figure 8- 49. VRRP Virtual Router Settings - Add
Description
Enter the name of a previously configured IP interface for which to create a VRRP entry.
This IP interface must be assigned to a VLAN on the Switch.
Enter a value between 1 and 255 to uniquely identify this VRRP group on the Switch. All
routers participating in this group must be assigned the same VRID value. This value MUST
be different from other VRRP groups set on the Switch.
Enter the IP address that will be assigned to the VRRP router. This IP address is also the
default gateway that will be statically assigned to end hosts and must be set for all routers
that participate in this group.
149