D-Link xStack DES-3800 Series User Manual page 197

VLAN Name Allows the entry of a name for a previously configured VLAN.
Source MAC Source MAC Address - Enter a MAC Address for the source MAC address.
Destination MAC Destination MAC Address - Enter a MAC Address mask for the destination MAC address.
802.1p (0-7) Enter a value from 0-7 to specify that the access profile will apply only to packets with this
802.1p priority value.
Specifies that the access profile will apply only to packets with this hexadecimal 802.1Q
Ethernet Type
Ethernet type value (hex 0x0-0xffff) in the packet header. The Ethernet type value may be set in
the form: hex 0x0-0xffff, which means the user may choose any combination of letters and
numbers ranging from a-f and from 0-9999.
Port The Access Rule may be configured on a per-port basis by entering the port number of the
switch in the switch stack into this field. When a range of ports is to be configured, the Auto
Assign check box MUST be clicked in the Access ID field of this window. If not, the user will be
presented with an error message and the access rule will not be configured. The beginning and
end of the port list range are separated by a dash. For example, 3 specifies port 3. 2 - 4
specifies the range of ports from 2 to 4.
To view the settings of a previously, correctly configured rule, click
below. Clicking the hyperlink for the Profile ID on the Access Profile Table will also bring up the Access Rule Display window.
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
Figure 10- 8. Access Rule Display window (Ethernet)
in the Access Rule Table to view the window shown
182