Ieee 802.1Q Vlans - D-Link xStack DES-3800 Series User Manual

Notes About VLANs on the DES-3800 Series
No matter what basis is used to uniquely identify end nodes and assign these nodes VLAN membership, packets cannot cross
VLANs without a network device performing a routing function between the VLANs.
The DES-3800 Series supports IEEE 802.1Q VLANs and Port-Based VLANs. The port untagging function can be used to remove
the 802.1Q tag from packet headers to maintain compatibility with devices that are tag-unaware.
The Switch's default is to assign all ports to a single 802.1Q VLAN named "default."
The "default" VLAN has a VID = 1.
The member ports of Port-based VLANs may overlap, if desired.

IEEE 802.1Q VLANs

Some relevant terms:
Tagging - The act of putting 802.1Q VLAN information into the header of a packet.
•
Untagging - The act of stripping 802.1Q VLAN information out of the packet header.
•
Ingress port - A port on a switch where packets are flowing into the Switch and VLAN decisions must be made.
•
Egress port - A port on a switch where packets are flowing out of the Switch, either to another switch or to an end
•
station, and tagging decisions must be made.
IEEE 802.1Q (tagged) VLANs are implemented on the Switch. 802.1Q VLANs require tagging, which enables them to span the
entire network (assuming all switches on the network are IEEE 802.1Q-compliant).
VLANs allow a network to be segmented in order to reduce the size of broadcast domains. All packets entering a VLAN will only
be forwarded to the stations (over IEEE 802.1Q enabled switches) that are members of that VLAN, and this includes broadcast,
multicast and unicast packets from unknown sources.
VLANs can also provide a level of security to your network. IEEE 802.1Q VLANs will only deliver packets between stations that
are members of the VLAN.
Any port can be configured as either tagging or untagging. The untagging feature of IEEE 802.1Q VLANs allows VLANs to work
with legacy switches that don't recognize VLAN tags in packet headers. The tagging feature allows VLANs to span multiple
802.1Q-compliant switches through a single physical connection and allows Spanning Tree to be enabled on all ports and work
normally.
The IEEE 802.1Q standard restricts the forwarding of untagged packets to the VLAN of which the receiving port is a member.
The main characteristics of IEEE 802.1Q are as follows:
Assigns packets to VLANs by filtering.
•
Assumes the presence of a single global spanning tree.
•
Uses an explicit tagging scheme with one-level tagging.
•
802.1Q VLAN Packet Forwarding
•
Packet forwarding decisions are made based upon the following
•
three types of rules:
Ingress rules - rules relevant to the classification of received
•
frames belonging to a VLAN.
Forwarding rules between ports - decides whether to filter or
•
forward the packet.
Egress rules - determines if the packet must be sent tagged or
•
untagged.
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
Figure 7- 1. IEEE 802.1Q Packet Forwarding
74