D-Link xStack DES-3800 Series User Manual page 211

Configure the following Access Rule Configuration settings for IP:
Parameter
Profile ID
Mode
Access ID
Type
VLAN Name
Source IP
Destination IP
Dscp (0-63)
Protocol
To view the settings of a previously correctly configured rule, click
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
Figure 10- 24. CPU Interface Filtering Rule Configuration – IP
Description
This is the identifier number for this profile set.
Select Permit to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select Deny to specify that packets that match the access profile are not forwarded by the
Switch and will be filtered.
Type in a unique identifier number for this access. This value can be set from 1 -65535.
Selected profile based on Ethernet (MAC Address), IP address or Packet Content.
Ethernet instructs the Switch to examine the layer 2 part of each packet header.
•
IP instructs the Switch to examine the IP address in each frame's header.
•
Packet Content Mask instructs the Switch to examine the packet header.
•
Allows the entry of a name for a previously configured VLAN.
Source IP Address - Enter an IP Address mask for the source IP address.
Destination IP Address- Enter an IP Address mask for the destination IP address.
This field allows the user to enter a DSCP value in the space provided, which will instruct the
Switch to examine the DiffServ Code part of each packet header and use this as the, or part of
the criterion for forwarding. The user may choose a value between 0 and 63.
This field allows the user to modify the protocol used to configure the Access Rule Table;
depending on which protocol the user has chosen in the Access Profile Table.
in the Access Rule Table to view the following screen:
196