D-Link xStack DES-3800 Series User Manual page 191

clicking the Clear All button (This button will not clear Address Binding ACL entries, which can only be deleted through the IP-
MAC Binding window). The page shown below is the Ethernet Access Profile Configuration page.
The following parameters can be set, for the Ethernet type:
Parameter
Profile ID (1-255)
Type
VLAN
Source MAC
Destination MAC
802.1p
Ethernet type
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
Figure 10- 2. Access Profile Table (Ethernet)
Description
Type in a unique identifier number for this profile set. This value can be set from 1 – 255, yet
only 9 access profiles can be created on the Switch.
Select profile based on Ethernet (MAC Address), IP address, or packet content mask. This
will change the menu according to the requirements for the type of profile.
Select Ethernet to instruct the Switch to examine the layer 2 part of each packet
•
header.
Select IP to instruct the Switch to examine the IP address in each frame's header.
•
Select Packet Content Mask to specify a mask to hide the content of the packet
•
header.
Selecting this option instructs the Switch to examine the VLAN identifier of each packet
header and use this as the full or partial criterion for forwarding.
Source MAC Mask - Enter a MAC address mask for the source MAC address.
Destination MAC Mask - Enter a MAC address mask for the destination MAC address.
Selecting this option instructs the Switch to examine the 802.1p priority value of each packet
header and use this as the, or part of the criterion for forwarding.
Selecting this option instructs the Switch to examine the Ethernet type value in each frame's
header.
NOTE: IP-MAC Binding ACL entries can only be removed form the Access
Profile table by using the IP-MAC Binding window, mentioned earlier in
this manual. The Clear All button will only remove entries created in the
Access Profile window.
176