D-Link xStack DES-3800 Series User Manual page 259

Click Apply to implement changes made.
To view Web-based Access Control status of individual ports, click the
Use the pull-down menu in the From and To fields to select a port or range of ports to be viewed for their Web-based Access
Control status. In the previous window, ports 1-10 have been selected to be viewed.
To set user accounts for the Web-based Access Control click Security > User Account Management which will open the
following screen for the user to configure.
To set the User Account settings for the Web-based Access Control by the Switch, complete the following fields.
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
NOTE: To enable the Web-based Access Control function, the redirection path field
must have the URL of the website that users will be directed to once they enter the
limited resource, pre-configured VLAN. Users which attempt Apply settings without
the Redirection Page field set will be prompted with an error message and Web-
based Access Control will not be enabled. The URL should follow the form
http(s)://www.dlink.com
NOTE: The subnet of the IP address of the authentication VLAN must be the same
as that of the client, or the client will always be denied authentication.
NOTE: A successful authentication should direct the client to the stated web page.
If the client does not reach this web page, yet does not receive a Fail! message,
the client will already be authenticated and therefore should refresh the current
browser window or attempt to open a different web page.
Figure 11- 54. Web-based Access Control Port State window
Figure 11- 5 . Web-based User Account Settings window 5
Show port state link to open the window seen below.
244