Basic Configuration - Step By Step - 2N BRI Lite User Manual

4.5 Basic Configuration – Step by Step
This subsection helps you put your BRI gateway in operation for the first time. Refer to
the paragraphs of
Install the GSM gateway as instructed in
insert the PIN–disabled SIM cards before the first launch.
Connect the GSM gateway to the Ethernet to be able to get connected to the
address mentioned in
address of your gateway is not suitable for your Ethernet installation, change the
IP address setting as follows:
Enter the new IP address of your GSM gateway to get connected to the web
interface.
Set the current time and date for the GSM gateway in the Gateway control –
Date/Time
Check the
Firmware/Licence
equipped with the proper licence (refer to
licence key.
Set the correct PIN code value in the Gateway configuration – System
parameters
Set new login data in the
Switch off the GSM gateway and insert the SIM cards. Connect the antenna to
the GSM gateway and switch the gateway on.
The GSM gateway factory configuration allows you to make outgoing calls without
any additional programming. All you have to do is set the correct values for the
BRI ISDN and VoIP interfaces.
Should you have problems with the gateway functions, follows the instructions below
please:
Read the User Manual carefully and check all the parameters.
Find answers to your questions at
Contact your servicing centre.
It is recommended that you should attend certified training courses at 2N to be able to
install the whole system successfully.
®
2N TELEKOMUNIKACE a.s., www.2n.cz
S. 3 for more detailed settings.
Subs. 4.1
Disconnect the configuration terminal from the Ethernet.
Disconnect the GSM gateway from the Ethernet.
Get an Ethernet switch or an Ethernet crossed cable.
With the crossed cable, interconnect the configuration terminal directly with
the GSM gateway.
With the Ethernet switch, connect the configuration terminal and GSM
gateway to the switch. We do not recommend you to connect any other
device.
Change the IPv4 setting in your configuration terminal Ethernet settings to,
e.g.: IP=192.168.1.200, Net mask: 255.255.255.0
Open your web browser and enter the IP address of your GSM gateway.
Complete the factory login data.
Change the required settings in the Gateway configuration – Ethernet
configuration section and save the changes into the GSM gateway.
Connect the GSM gateway to a standard Ethernet.
Rechange the IP settings of the configuration terminal and reconnect the
terminal to a standard Ethernet.
menu.
Licence status
menu. If the status is not unlocked, your GSM gateway is not
menu to meet the PIN code of the SIM cards used.
Gateway configuration – Login configuration
Subs. 2.2 . Remove the SIM cards or
, page from the web interface. If the default IP
for 'unlocked' in the
Subs 4.2 ). Contact your dealer for the
http://faq.2n.cz (Frequently Asked Questions).
Gateway control –
menu.
43