Ethernet Interface; Mac Address - 2N BRI Lite User Manual

4.1 Ethernet Interface

The BRI
http://IP_gateway_address
NB, Tablet, etc.) has been connected for successful connection to the BRI gateway
configuration interface. The device also supports configuration via an extended AT
command set on the Telnet interface (IP port 23).
The BRI gateway supports DHCP (client). By default, the DHCP support is disabled.
Use the web configuration interface in the Gateway configuration – Ethernet
configuration
Ethernet Interface Factory Settings
IPv4 address
IP mask
User name
User password

MAC Address

The BRI gateway has a unique, factory–set MAC (Media Access Control) address. Refer
to the rear side label of your device or the gateway web interface for the MAC address.
®
2N TELEKOMUNIKACE a.s., www.2n.cz
gateway can be
. Make sure that a device equipped with a web browser (PC,
Tip
The device also supports configuration via an extended AT
command set on the Telnet interface (IP port 23). Refer to
6 , page for details.
Tip
If DHCP is active, use specialised detection software (for LANs
only) to identify the assigned IP address. Refer to the
www.2n.cz web sites, BRI Gateways (IP Scanner) for the
software.
section to set the Ethernet interface.
Caution
Change the user name and password during your
configuration to avoid unauthorised access to your gateway
configuration! Refer to page for details!
Tip
In the event of data loss or configuration interface unavailability,
perform the factory reset to retrieve the data. Doing so,
however, you reset all the default values in your gateway. Refer
to Subs. 4.4 , p. for details.
fully configured via
192.168.1.2
255.255.255.0
Admin
2n
the web interface
Subs.
first gateway
at
38