Ethernet Interface - 2N BRI Lite User Manual

4.1 Ethernet Interface

The BRI gateway
http://IP_gateway_address
(PC, NB, Tablet, etc.) has been connected for successful connection to the BRI
gateway configuration interface. The device also supports configuration via an
extended AT command set on the Telnet interface (IP port 23).
Tip
The device also supports configuration via an extended AT command
set on the Telnet interface (IP port 23). Refer to
The BRI gateway supports DHCP (client). By default, the DHCP support is disabled.
Tip
If DHCP is active, use specialised detection software (for LANs only) to
identify the assigned IP address. Refer to the
Gateways (IP Scanner) for the software.
Use the web configuration interface in the Gateway configuration – Ethernet
configuration section to set the Ethernet interface.
Ethernet Interface Factory Settings
IPv4 address 192.168.1.2
IP mask 255.255.255.0
Gateway 192.168.1.1
User name Admin
User password 2n
Caution
2N TELEKOMUNIKACE a.s., www.2n.cz
can be fully configured
. Make sure that a device equipped with a web browser
via the web interface
Subs. 6 , page for details.
www.2n.cz web sites, BRI
at
46/152