Ethernet Cable And Ac Adapter; Ac Adapter Connection; Operation With Breakout Box - Fluke tix640 User Manual

Ethernet Cable and AC Adapter

The Ethernet cable is used in order to connect the
thermography camera to the 8-pin LEMO socket (left-
hand side, blue mark).
The 14-pin connector of the ac adapter is plugged into the
right-hand side LEMO socket with the red mark pointing
to the top. See Figure 1-2.
Ethernet
AC Adapter
Figure 1-2. Ethernet Cable and AC Adapter

AC Adapter Connection

To operate while permanently connected to a notebook or
PC, the power should be supplied using the ac adapter
(see Figure 1-3) with the 14-pin LEMO connector on
right-hand side socket.
When the ac adapter is connected, the camera is
automatically supplied by the ac adapter and no longer by
the rechargeable battery. However, the rechargeable
battery is not charged at the same time.

Operation with Breakout Box

Using the breakout box will expand the connection
options of the thermal imager, see Table 1-7. The
interfaces 2 x analog output, 2 x trigger E/A, PAL/NTSC-
hvh057.eps
FBAS, as well as the digital RS232 interface are
accessible via the breakout box.
Before You Start
Start-Up
Figure 1-3. AC Adapter
1
hvh058.eps
1-27