Table of Contents
Advertisement
Charge Batteries
To prevent damage to the Imager:
•
Do not store the batteries in extreme cold environments.
•
Do not attempt to charge the batteries in extreme cold environments.
Do not incinerate the Product and/or battery.
Before you use the Imager for the first time, charge the battery for at least 2.5 hours. The
battery status shows on the five-segment charge indicator.
New batteries are not fully charged. Two to ten charge/discharge cycles are
necessary before the battery charges to its maximum capacity.
To charge the battery, use one of the options that follow.
Two-Bay Battery Charger Base
To charge the battery in the charger base:
1. Connect the ac power supply to the ac wall outlet and connect the dc output to the
charger base.
2. Put one or two smart batteries into bays of charger base.
3. Charge batteries until charge LEDs on charger base are a solid green.
4. Remove smart batteries and disconnect the power supply when batteries are fully
charged.
AC Power Socket on Imager
Make sure that the Imager is near room temperature before you connect it to the
charger. See the charging temperature specification. Do not charge in hot or cold
areas. When you charge in extreme temperatures, battery capacity may be
decreased. When you charge in extreme temperatures, the battery may not charge.
To charge the battery with the ac power socket on the Imager:
1. Connect the ac power adapter into an ac wall outlet and connect the other end to the ac
power socket on the Imager.
2. Charge until the charge indicator on the display does not flash.
1.800.561.8187
W Caution
W Caution
~
Note
Note
bz
flashes on the display while the battery charges.
www.
.com
Thermal Imager
Maintenance
information@itm.com
45
Advertisement
Table of Contents
