Data Transmission To The Computer; Start-Up; Hand Strap; Tripod - Fluke tix640 User Manual

Data Transmission to the Computer

®
SmartView software will enable the transmission of data
via the optional GigE Vision (available in 2015).
Another data transmission method is to read out the
SDHC card by means of a card reader.

Start-Up

Hand Strap

The thermal imager is designed as highly portable system
for single-hand operation. Initially, adjust the hand strap
attached to the handle piece as required. For this, open
the loop of the hand strap and adjust the length of the belt
strap in such a way that you can comfortably access the
controls with your fingers. Then, close the hook and loop
fastener of the loop.

Tripod

The thermography camera is equipped with a 1/4" photo
thread (DIN 4503) on the bottom of the housing. In order
to achieve rigid camera images, particularly for the
SuperResolution mode, it is recommendable to fix the
thermal imager to a tripod.
 Caution
Observe the maximum penetration depth of
the photo thread of 4.5 mm (DIN 4503).

Data Transmission to the Computer

Power Supply

When using a rechargeable battery, the battery must be
placed on the adapter plate. Push down the rechargeable
battery until it engages. In this, the rechargeable battery
must be pushed slightly to the front towards the lens. In
order to use the thermal imager, please only use the
®
genuine SONY rechargeable batteries NP-QM91D.
The ac adapter is connected to the 14-pin socket on the
right-hand side of the backside of the thermography
system.

Memory Card

The SD card slot is located on the left-hand side of the
camera. In order to guarantee the degree of protection
IP54, the slot is protected by a cover. Pull off the cover to
insert a memory card and insert the SD card into the card
slot. Please observe the proper orientation of the card (▲
to the top). Afterwards, the cover must be re-closed. This
is the only way to ensure the complete degree of
protection of the device.
1
Before You Start
1-25