Optomechanics; Controls; Power Supply - Fluke tix640 User Manual

Optomechanics

With the help of an optomechanic assembly, the following
functions are implemented:
®
LaserSharp Auto Focus
•
measuring range switch-over (apertures)
•
internal NUC (Non Uniformity Correction) with shutter
•
Furthermore, this assembly optionally comprises a
module for hardware-based increase of the geometric
resolution of the thermography system to 2048 x 1536 IR
pixels (detector with 1024 x 768 pixels) and
1280 x 960 IR pixels (detector with 640 x 480 pixels) in
SuperResolution mode.

Controls

The thermal imager is controlled by means of a focus
rocker switch  with center function for autofocus, the
function buttons  Automatic,  Temperature,
Start/Stop/Save, and the multi-function buttons  and 
at the right top. On the backside of the camera, a power
button for right-thumb operation, a joystick

center function (Enter), and the  button (Cancel) can be
found. The controls of the thermal imager are arranged
for single-hand operation with the right hand. Another
multi-function button  can be found at the top of the
handle. When carrying the camera on its handle, it can be
operated using the thumb of your right hand.
Specific modes of camera operation and presettings can
be configured using menus. Chapter 2 contains a detailed
description of how to operate the thermography system,
as well as a detailed description of the menu structure.
The thermal imager can be controlled remotely via the
RS232 or GigE-Vision interfaces.

Power Supply

Optionally, an external 15 V ac adapter (accessories) or a
rechargeable lithium-ion battery 7.2 V (accessories) can
be used to supply the thermal imager with power.
The ac adapter is connected to the 14-pin (right-hand
side) LEMO socket on the backside of the housing. The
rechargeable battery is inserted vertically into the
designated position on the backside of the thermography
system (see Chapter 3).
with

Before You Start
Technical Description
1-11
1