Front Bezel; Removing The Front Bezel - NEC EXPRESS5800/120Rc-2 Service Manual

Front Bezel

Removing the Front Bezel

Refer to the Figure 4-1 and remove the front bezel of the server as follows:
1. Terminate all applications.
2. Open the front door of the system rack.
3. If the front server bezel is locked, unlock it.
4. Grasp the right edge of the front bezel and pull the bezel towards you to
open it.
5. Slide the front bezel left to disengage the mounting tabs and remove the
front bezel from the chassis.
6. Press the power ON/OFF button (Figure 4-1, A) to power down the server.
7. Remove the two screws securing the server to the front of the system rack.
To reduce the risk of personal injury, be careful when
pressing the component rail release latches and sliding the
component in or out of the rack. The slide rails could pinch
your fingertips.
8. Pull the server out of the rack until the component rail release latches
engage. The component rail release latches on either side of the server lock
the server onto the slide rails.
4-4 Disassembly and Reassembly
!
WARNING
2
Figure 4-1. Opening the Front Bezel
A
1