NEC EXPRESS5800/120Rc-2 Service Manual page 125

13. Exert a downward pressure on the PCI I/O board at the points shown in
Figure 4-57 until the board is seated in its connector on the system board.
14. Install Pentium III processor(s) and memory into the replacement system
board as required following procedures found in this chapter.
15. Replace the top cover.
Your system weighs approximately 65 pounds (29.25 kg). If
your system contains numerous optional boards and
peripheral devices, it will weigh more. To avoid personal
injury, make sure you have someone help you lift or move
the system.
16. Install the system into the system rack.
17. Plug in the server power cord, and power on the server.
18. Install and secure the front bezel following procedures described earlier in
this chapter.
!
WARNING
Disassembly and Reassembly 4-49