Installing A Removable Media Device - NEC EXPRESS5800/120Rc-2 Service Manual

Installing a Removable Media Device

1. Power down the system and remove top cover as described earlier in this
chapter.
2. Disconnect the CD-ROM/diskette signal and voltage cables connected to
these devices. See Figure 4-37.When removing the diskette signal cable, you
must first push up on the cable lock (A) before pulling the ribbon cable (B)
out of the connector. Disconnect the CDROM signal cable (C) and the
voltage cable (D).
D
Figure 4-37. Removing CD-ROM/Diskette Device Cables
3. Remove the CD-ROM/diskette carrier from the peripheral bay by pushing in
on the carrier rail clips and then pulling the carrier completely out of the bay
(Figure 4-38).
Figure 4-38. Removing CD-ROM/Diskette Device Bay
4-34 Disassembly and Reassembly
C
B
A