Note:
Perform the next step if a drive carrier is located
in Bay B. Otherwise go to Step 5
4. Grasp the handle of the hard disk carrier and unlock the lever located on the
left side of the carrier handle, See Figure 4-39, A. The hard disk carrier will
slide out approximately 1/2-inch so that its handle is fully accessible. Pull
the drive carrier completely out of the bay.
A
Figure 4-39. Removing the Hard Disk Carrier from the Drive Bay
5. Remove the two screws securing the hard disk drive bay 5 to the system. See
Figure 4-40.
Figure 4-40. Removing Hard Disk Drive Bay Screws
Disassembly and Reassembly 4-35