Initial Start-Up - RED COMPACT 35 Installation And User Manual

7 - INITIAL START-UP

BEFORE START-UP
GENERAL PRECAUTIONS
Remove all components that could burn from the brazier (manual, various adhesive labels and any polystyrene).
Check that the brazier is positioned correctly and rests properly on the base.
After a long period of inactivity, remove any pellets left in the hopper (using a vacuum cleaner with a long pipe ), as they
could have absorbed moisture, thereby altering their original characteristics and no longer being suitable for combustion.
The first start-up may not be successful as the feed screw is empty and does not always manage to load the required
amount of pellets in the brazier in time for the fire to be regularly ignited.
CANCEL THE FAILED START-UP ALARM STATUS BY PRESSING AND HOLDING KEY 1 (ESC). REMOVE THE PELLETS FROM THE
BRAZIER AND REPEAT START-UP.
If a flame does not ignite after a number of failed start-ups, even though the pellet supply is correct, make sure the brazier is set in place
correctly, which must be interlocked in its seat and free from any ash deposits. If no anomaly is found during this inspection, there
may be a problem with the product components or installation may not be correct.
REMOVE THE PELLETS FROM THE BRAZIER AND CONTACT AN AUTHORISED TECHNICIAN.
Avoid touching the boiler during the initial start-up, as the paint in this stage hardens; by touching the paint, the
steel surface may be exposed.
If necessary, touch up the paint with the spray can in the original colour (see the "Accessories for pellet boilers" section).
It is good practice to guarantee effective ventilation in the room during the initial start-up, as the boiler will emit some smoke
and smell of paint.
Do not stand close to the product and air the room. The smoke and smell of paint will disappear after about an hour of
operation, however, remember they are not harmful in any case.
Technical Dept. - All rights reserved - Reproduction is prohibited
27