Installing The Pcie Card Into The Io Module - Dell Edge 5000 Series Installation And Operation Manual

NOTE: Connect a power cable to the 24 V AC/DC or 19.5 V DC power adapter port on the power module.
NOTE: The power adapter and sealed lead-acid battery is sold separately.
NOTE: To enable and use the IO expansion module, you must also install the power module.

Installing the PCIe card into the IO module

CAUTION: Electrical and electronic devices are sensitive to electrostatic discharge (ESD). Exposure to ESD can harm
your device and potentially cause it not to function properly. Ensure that you are properly grounded before handling the
mobile broadband card.
NOTE: Install the PCIe expansion card in the IO expansion module before mounting it on a wall mount or DIN rail.
1. Open the IO module.
a. Remove the dust caps and loosen the access cover screw that secures the IO expansion module to the cover.
b. Slide the module in the direction shown, and then carefully lift the top cover from the module.
CAUTION: Remove the cover carefully to avoid damaging the LED light cable, which is mounted on the bottom of
the cover.
77