Setting Up The Enclosure - Dell Edge 5000 Series Installation And Operation Manual

Hide thumbs Also See for Edge 5000 Series:
Table of Contents

Advertisement

Features
6
Cable tie-off (17)
7
Cable conduit openings (8)
8
Primary ground (internal)
9
Primary ground (external)
10
Door-stop cables (2)
11
Door thermal ribs

Setting up the enclosure

1.
Install the enclosure's wall-mount bracket at a desired location and secure it to the wall using the wall-mount screws.
NOTE: Ensure that the notch on the bracket is on the top.
NOTE: The wall-mount screws are not included with the enclosure.
2.
Open the enclosure.
3.
Place the enclosure on the wall-mount bracket, and align the tab on the back of the enclosure so that it fits into the notch on
the wall bracket.
To prevent accidental cable disconnection, tie all cables to the
cable tie-off guides.
Route the cables through the conduits (1 inch and 0.75 inch
diameter).
Connect the grounding cable to the system.
Connect the grounding cable to the system.
Restricts the door from opening.
Dissipates the heat generated by the system.
91

Advertisement

Table of Contents
loading

This manual is also suitable for:

Edge 5100 series

Table of Contents