Oce CS6407 Quick Reference Manual page 9

11
Feed the media until the media end almost
reaches the fl oor.
In this state, smooth out the media toward the both
sides on the platen to make the media center tense.
Note
- If the media is set with a distortion or wrinkles, this may cause a
media jam or skew.
12
Feed back the media to the top of the front
paper guide.
Feed back the media while pressing the center of
the media gently at the supply side.
- Step 12 is important to set the media properly.
13
Rotate the pressure control knob
counterclockwise to lower the pressure roller.
Takeup side
or
Pressure control knobs
14
Platen
15
Front paper guide
16
[NEW MEDIA ENTRY] is displayed at the end of the registered
media.
Press the
The media registration procedure is the same as the
registration from the registration menu.
Press the
to the media type selection menu.
To return to the value before input, press the
Supply side
Set the media edge guards and close the front
cover.
C H E C K E D G E G U A R D
* O K ?
Check that the media edge guards are not under the
media or thick media is not caught by inserting it
forcibly. After confi rming visually that the media edge
guards are properly set, press the
Select roll media or cut-sheet media.
S E L E C T M E D I A
R O L L / S H E E T : R O L L
R O L L / S H E E T : S H E E T
Either [roll] or [sheet] can be selected with the
or key.
Here, select [roll] and press the
(To return to the media selection, press the
key.)
Select the type of media.
Select the registered type of media with the
keys and press the
S E L E C T M E D I A
M E D I A : T Y P E 0 2
M E D I A : T Y P E 0 2
To register new media
key to enter MEDIA REG MENU.
key to return from the media registration menu
S E L E C T M E D I A
M E D I A : T Y P E 0 2
M E D I A : T Y P E 0 2
(The registered media is displayed.)
S E L E C T M E D I A
N E W M E D I A E N T R Y
(Enter the media registration menu.)
key.
key
key.
CANC EL
and
key.
key.
CANCE L
9