ZyXEL Communications P-660HN-51 User Manual page 183

Table 74 Class Setup: Add/Edit (continued)
LABEL DESCRIPTION
Classification Order Select an existing number for where you want to put this classifier to move the
classifier to the number you selected after clicking Apply.
Select Last to put this rule in the back of the classifier list.
From Interface If you want to classify the traffic by an ingress interface, select an interface from
the From Interface drop-down list box.
To Interface If you want to classify the traffic by an egress interface, select an interface from
the To Interface drop-down list box.
Ether Type Select a predefined application to configure a class for the matched traffic.
If you select IP, you also need to configure source or destination MAC address, IP
address, DHCP options, DSCP value or the protocol type.
If you select 802.1Q, you can configure an 802.1p priority level.
Source
Address Select the check box and enter the source IP address in dotted decimal notation.
A blank source IP address means any source IP address.
Subnet Netmask Enter the source subnet mask.
Port Range If you select TCP or UDP in the IP Protocol field, select the check box and enter the
port number(s) of the source.
MAC Select the check box and enter the source MAC address of the packet.
MAC Mask Type the mask for the specified MAC address to determine which bits a packet's
MAC address should match.
Enter "f" for each bit of the specified source MAC address that the traffic's MAC
address should match. Enter "0" for the bit(s) of the matched traffic's MAC
address, which can be of any hexadecimal character(s). For example, if you set
the MAC address to 00:13:49:00:00:00 and the mask to ff:ff:ff:00:00:00, a packet
with a MAC address of 00:13:49:12:34:56 matches this criteria.
Exclude Select this option to exclude the packets that match the specified criteria from this
classifier.
Destination
Address Select the check box and enter the source IP address in dotted decimal notation.
A blank source IP address means any source IP address.
Subnet Netmask Enter the source subnet mask.
Port Range If you select TCP or UDP in the IP Protocol field, select the check box and enter the
port number(s) of the source.
MAC Select the check box and enter the source MAC address of the packet.
MAC Mask Type the mask for the specified MAC address to determine which bits a packet's
MAC address should match.
Enter "f" for each bit of the specified source MAC address that the traffic's MAC
address should match. Enter "0" for the bit(s) of the matched traffic's MAC
address, which can be of any hexadecimal character(s). For example, if you set
the MAC address to 00:13:49:00:00:00 and the mask to ff:ff:ff:00:00:00, a packet
with a MAC address of 00:13:49:12:34:56 matches this criteria.
Exclude Select this option to exclude the packets that match the specified criteria from this
classifier.
Others
Chapter 17 Quality of Service (QoS)
P-660HN-51 User's Guide
183