Fujitsu Siemens Computers PRIMERGY TX200 S4 Service Supplement Manual page 33

Replacement routines
Centering tabs
Figure 15: Removing the screws
Ê Remove the two screws (see the circles).
Ê Lift the backplane a little way and tilt it slightly away from the hard disk cage.
Ê Take the backplane out downward.
Ê Place the new 2.5" HDD backplane against the hard disk cage at a slight
angle. Hook the backplane in the upper edge and then lower the backplane.
Metal tongues on the upper edge of the hard disk cage ensure that it is
automatically centered.
Ê Fasten the backplane using the two screws.
Ê Attach the connectors of the SATA cable and the power cable to the 2.5"
HDD backplane.
Ê Reinstall all hot-plug hard disk drives in their former slots.
Ê Close the server and connect all power plugs (for a detailed description see
the Options Guide).
TX200 S4
Replacing the 2.5" HDD backplane
Service Supplement 33