Part 11. Disassembly Instructions; Cases; Keyboard And Lcd Pcbs - Tandy 102 Service Manual

II. DISASSEMBLY INSTRUCTIONS
Cases
1. Disconnect the cables from the unit.
Taking care not to scratch the LCD screen and key tops, turn the unit over and remove 4 screws
A from the upper and lower cases.
2. Remove the upper case.
Therefore, the upper and lower cases are secured by snaps. Pull up the front of the upper case
first, as shown below.
Also, do not apply too much force when pulling it.
A
Figure 2-1. Top Case Removal
Keyboard and LCD PCBs
1. Disconnect the flat cable from the connector on the keyboard PCB.
2. Remove the keyboard PCB.
3. Disconnect the flat cable from the connector on the LCD PCB.
4. Remove the LCD PCB.
V
V
1 I
1
e
C5
Figure 2-2. Keyboard and LCD PCBs Removal
2-1