Table of Contents
Advertisement
The main beam on/off is controlled by a sensor or
Activating / Deactivating the system takes place in the Infotainment menu
→ → Light → Light Assist.
Conditions for the system function
The system is activated.
The light switch is in the position .
The vehicle speed is over 60 km/h or for some countries over 40 km/h.
The windscreen is clean in the sensor area.
Switch on the system
›
Push the lever into the sprung position
light lights up in the instrument cluster display.
Switch off the system
›
If the high beam is switched on automatically, move the lever into the sprung
position
. The warning light goes out. The high beam turns off.
B
›
If the high beam is is not switched on automatically, move the lever into the
sprung position
. The warning light goes out. The high beam turns on.
A
The high beam switches off automatically when the speed falls below 30 km/h
(but the system remains switched on).
If there is a system fault, an error message will appear in the instrument clus-
ter display. Seek help from a specialist garage.
WARNING
The system is used only for support, thus the driver is not released from his
or her obligation to manually adjust the main or low beam according to the
given ambient conditions (e.g. in unfavourable lighting and weather condi-
tions, as when passing poorly lit road users, if necessary, when the visual
range of the sensor is limited by an obstacle).
CAUTION
Do not cover the sensor - the system may be affected.
» Fig.
60.
» Fig. 60
The following indicator
A
Fog lights/rear fog light
Read and observe
on page 62 first.
Switching on the fog lights / rear fog lights is possible if the following con-
ditions apply.
The lights switch is in position, or
›
To switch on the fog lights, pull the light switch in position
light
illuminates in the instrument cluster.
›
To switch on the rear fog light, pull the light switch to position
cator light
will light up in the instrument cluster.
If the vehicle is not fitted with fog lights, the rear fog light is switched on by
pulling out the light switch to the only possible setting.
The fog lights/rear fog light are switched off in the reverse order.
Note
If an accessory is connected to the trailer socket, the rear fog lamp does not
light up on the vehicle.
Fog lights with CORNER function
Read and observe
on page 62 first.
The CORNER function automatically switches on the fog lights on the respec-
tive side of the vehicle (e.g. when cornering), if the following conditions are
fulfilled.
The turn signal is turned on or the front wheels are severely locked (in the
event of conflict between the two versions, has turn signal has the higher
priority).
The vehicle speed is below 40 km/h.
Fig. 61
Light switch – switch on front
and rear fog lights
» Fig.
61.
; the warning
1
, the indi-
2
Lights and visibility
65
Advertisement
Table of Contents
