Table of Contents
Advertisement
Unpack and Installation
As a final step, turn on each screen of the device by pressing the
7.
corresponding power switch located on the front panel.
The pedestal and the monitor are packaged separately.
Connect a standard signal lines to the corresponding input port. All BNC
connector impedance must be 75Ω.
Please use the power adapter supplied to avoid unnecessary trouble.
Use the power adapter and cord to connect single-phase three-wire AC
power or following the local power supply conditions. Make sure the power
cord grounding well.
The factory default value for IP address is 192.168.1.86.
6
Advertisement
Table of Contents
