LifeSize Icon 800 Installation Manual page 6

2. To connect your camera to the codec, insert the HDMI cable into the HD port on the camera and plug
the opposite end into the appropriate
Insert the power adapter cable into the power port on the back of the camera, and plug the power
adapter into a power outlet.
Optional: Install the glare visor, using the notches on the lens barrel to guide the visor into its correct
position. Use the visor only if it improves the image in your environment.
CAUTION Do not attempt to pick up the camera by the glare visor, as it might pull
loose and damage the camera.
Icon 800 only: You can optionally install up to three additional devices in the remaining video ports.
3. Insert the appropriate end of the display cable (HDMI or DVI-I to HDMI) into the port on the back of
your display and the opposite end into the
cord into a power outlet.
To connect a second display, insert the video display cable into the HDMI connector on the back of
your display and the DVI connector into the
power outlet. Lifesize Icon automatically configures the second display.
NOTE Connecting a second display requires a license key.
4. Insert the network cable into the network port marked with the LAN symbol
codec. Insert the opposite end of the network cable into a network port on the wall.
5. Insert one end of the Lifesize Link cable or Lifesize Link Adapter and cable into the
back of the codec and the other into the Lifesize Phone or optional MicPod.
Cable status indicators for the Lifesize Link adapter include:
-
Solid green at both ends when ready.
-
Blinking green when awaiting further action (such as plugging in the opposite end).
-
Blinking yellow when a fault occurs. Common fault conditions include plugging the cable into a
POE switch instead of the audio device, or disconnecting the audio device.
Only one adapter per codec is supported. For additional audio devices, you must use the Lifesize Link
cable only.
Up to two Lifesize Digital MicPods can be deployed in conjunction with Lifesize Phone. For a dual
MicPod configuration, use the second Lifesize Link cable to connect the first MicPod to the second
MicPod.
Icon 800 only: You can alternatively connect additional speakers or microphones using the Phoenix
connectors included with your system.
WARNING
Lifesize recommends that you use a cable tie to secure the cable to the
back of the codec (on Icon 600 at the location marked
port on the codec.
port on the back of the codec. Insert the display power
port on the codec. Attach the display power cord to a
Lifesize Icon Installation Guide
on the back of the
port on the
).
6