LifeSize Icon 800 Installation Manual page 4

Positioning the Rack Mounting Hardware
Icon 800 ships with the following rack mounting hardware:
•
One rack mounting bracket with four flat head screws installed at the front of each side of the chassis.
•
Four pan head screws and four washers installed in the middle of each side of the chassis.
•
Four pan head screws and four washers installed at the back of each side of the chassis.
You can leave the rack mounting brackets in their default position, remove the brackets entirely, or move
the brackets to the middle or back positions on each side of the chassis.
Removing the Brackets
1. Starting at the right side of the chassis (facing the front with the plastic bezel and Lifesize logo),
remove the four flat head screws and the rack mounting bracket from the chassis.
NOTE If you wish to move the bracket to another position on the chassis, skip the
rest of this procedure and proceed with step 2 of
2. From the middle position on the side of the chassis, remove the top two pan head screws and washers
and the lower pan head screw and washer closest to the front of the chassis.
3. At the front position on the side of the chassis, replace two pan head screws and washers in the
bottom two holes and one pan head screw and washer in the top hole closest to the front of the
chassis.
4. Tighten all screws with 10 in-lb. of torque.
5. Repeat these steps to remove the left rack mounting bracket.
Moving the Brackets
1. Starting at the right side of the chassis (facing the front with the plastic bezel and Lifesize logo),
remove the four flat head screws and the rack mounting bracket from the chassis.
2. Remove the four pan head screws and washers from the position to which you want to move the
brackets, at either the middle or the back of the chassis.
3. Attach the bracket to the chassis with the four flat head screws at the position from which you removed
the screws and washers in step 2.
4. Replace the four pan head screws and the washers at the position at the front of the chassis.
5. Tighten all screws with 10 in-lb. of torque.
6. Repeat these steps to move the left rack mounting bracket to the same position on the left side of the
chassis.
Lifesize Icon Installation Guide
Moving the Brackets.
4