Advertisement
2-3.
Selecting fi rmware
Select the fi rmware to be updated.
As the fi le select message appears by pressing the [Browse]
button, select the fi rmware.
• bkn2_all-x-x-x-xx_Rio3224-D.dnt (Rio3224-D)
(x-x-x-xx represents the version number.)
2-4.
Selecting device
When Rio3224-D connected through the network is found, it is
indicated in the list of items to be updated.
Put a check mark at the left end of Rio3224-D to be updated.
At this time, do not select more than one but execute updating
one by one.
2-5.
Executing updating
Press the [Start] button, and a popup to confi rm updating will
appear.
Use care so that no network disconnection or Rio power shut-
off occurs while updating is going on
Press the [OK] button to start updating.
The screen display during updating is as shown below.
("Updating (1/1)" is indicated in the status column.)
2-6.
Completing updating
When updating is over, a popup confi rming it will appear.
If an error has occurred, refer to 3.
Press the [OK] button, and the screen display will be as shown
below.
("Update Done" is indicated in the status column)
2-7.
End of application
Press the [X] mark at the upper right to end the application
2-8.
Turning off power of Rio3224-D
Turn off the power of Rio3224-D once and restart, and the
Brooklyn2 module can be used as an updated module.
3. In case of updating failure
If an error message is indicated in the status column, do
not turn off the power switch of Rio3224-D but execute 2.
Updating procedure again.
Rio3224-D
85
Hide quick links:
Advertisement
Chapters
