Hard Drives; Drive 1 And 2 In The Drive Bays - HPE ProLiant ML10 Gen9 Maintenance And Service Manual

Open the tower bezel.
5.

Hard drives

Drive 1 and 2 in the drive bays

CAUTION: To prevent improper cooling and thermal damage, do not operate the server
unless all bays are populated with either a component or a blank.
To remove the component:
Power down the server (on page 24).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Remove the access panel (on page 24).
3.
To disconnect power and SATA cables from drive 1 and the system board, do the following:
4.
Disconnect SATA cable from drive 1.
a.
Disconnect power cable from drive 1.
b.
Removal and replacement procedures 26