10. Perform the Running Belt Tensioning procedure found in Section 4.
Take Up Roller Replacement
This procedure is to be used to replace a take up roller while maintaining the running belt's
original tension and tracking settings. Two running belt gauges, Precor part number 20007-101,
are required. It is important that this procedure be followed to maintain correct running belt
tension. Over tensioning the belt will lead to premature running belt wear, premature driver
roller bearing failure and premature take up roller bearing failure.
1. Remove the end caps and belt guard from the rear of treadmill to expose the take up roller mounting
bolts.
2. Remove the finger guard located in front of take up roller.
3. Remove both take up roller mounting bolts. Remove the take up roller from the treadmill.
4. Slide the replacement take up roller into the running belt and set it in its mounting position.
5. Hand start both take up roller mounting bolts that were removed in step 5.
6. Perform the Running Belt Tensioning procedure found in Section 4.
©2014 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Page 30 of 56