Products Introduction; Important Safety Precautions; Main Technical Parameters; Mechanical Installation - JOYTECH PY500AC User Manual

PY500AC SLIDING GATE OPERATOR
1. 1. 1. 1. Products Products

Products introduction

Products introduction introduction introduction
please please read read the the instructions instructions
please please read read the the instructions instructions carefully
MCU MCU MCU MCU is is is is supplied supplied supplied to to to to control supplied control control the control
Keypad Keypad Keypad Keypad / / / / single single button single single button button button interface.
P P P P hoto hoto hoto hoto beam beam beam safety beam safety safety safety beam beam beam interface. beam
User User can can select select Auto-close Auto-close
User User can can select select Auto-close Auto-close function.
Manual key release design
Manual Manual Manual key key release key release release design design for design
2. 2. 2. 2. Important Important Important Important safety safety information safety safety information information information
Carefully read and follow all safety precautions and warning before attempting to install and use this
automatic gate operator.
Make Make sure sure the the Power Power
Make Make sure sure the the Power Power supply(AC220V
supply supply in in in in your your area.
supply supply your your area. area. area.
3. 3. 3. 3. Main Main Main technical Main technical technical technical parameters parameters parameters parameters
Type
Power supply
Motor speed
Rated output power of motor
Remote control operating distance
Remote control mode
Output shaft height
Max. gate weight
Output torque
Limit switch
Noise
Duty cycle
extra remote control
Environmental temperature
Gate Move speed
4. 4. 4. 4. Mechanical Mechanical

Mechanical Installation

Mechanical Installation Installation Installation
The PY500AC will handle gate weighting up to 500kg and up to 12m if the proper installation procedures
have been followed.
The PY500AC gate operator operates by forcing a drive rack by a drive gear. The entire configuration is
shown in the diagram below. The gate operator must be installed on the inside of the gate.
carefully carefully before before
carefully before before proceeding.
the the the gate gate gate gate operator. operator. operator. operator.
interface. interface. interface.
interface. interface. interface.
function. function.
function.
for emergency purposes.
for for emergency emergency purposes. emergency purposes. purposes.
supply(AC220V supply(AC220V or or or or AC110V) supply(AC220V AC110V) AC110V) of of of of the AC110V)
proceeding. proceeding.
proceeding.
the the gate gate operator operator operator is is is is suitable
the gate gate operator
PY500AC
220V, 50Hz
42rpm
150W
30m (Frequency: 433.92mHz)
Single button
58.5mm
500Kg
14N·m
Spring limit switch
≤60dB
S2, 15 minutes
20
-20°C~+50°C
12m/min
2
suitable suitable for for the the
suitable for for the the power
PY500ACU
110V, 60Hz
47rpm
power power
power