Installing The Iq Envoy - Part 2; Detect The Devices; Method A: Provision Devices With Installer Toolkit; Method B: Discover Devices With Installer Toolkit - enphase IQ Envoy Installation And Operation Manual

Installing the IQ Envoy – Part 2
You must complete installation Part 2 after installing the PV system.

5. Detect the Devices

Use one of the following methods to detect devices (Enphase Microinverters and/or Enphase Batteries).

Method A: Provision Devices with Installer Toolkit

Use the Installer Toolkit mobile app to configure the IQ Envoy with the serial numbers of the installed
devices.
a. Launch Installer Toolkit and tap View Systems.
b. Select the system you are working with, or tap [+] to add a system.
c. Connect to the IQ Envoy with your mobile device as described in the side note.
d. Return to Installer Toolkit. If the serial number for the IQ Envoy you are installing is not displayed on
the System Overview screen, tap the [+] next to the word Envoys. When the app displays the serial
number of the IQ Envoy, tap it to add it to the system.
e. Following the on-screen instructions, use the Installer Toolkit
app to create the arrays and scan the serial numbers from the
installation map.
Tap the Connect button. This provisions the scanned devices
f.
on the IQ Envoy.
g. When prompted, confirm the number of devices that you
installed.
h. If your system requires a region-specific grid profile, select and
apply a grid profile to the devices. (Systems in Hawaii and
systems with Enphase Batteries require you to set a profile.)
The Device Communications LED
provisioned devices are communicating or solid amber if any devices
are not communicating.

Method B: Discover Devices with Installer Toolkit

Use the Installer Toolkit mobile app to set the number of devices the IQ
Envoy should search for on the power line.
a. Connect to the IQ Envoy with your mobile device as described in
the side note.
b. Launch Installer Toolkit and tap Connect to an Envoy.
c. When prompted, enter the number of devices that you installed.
d. If your system requires a region-specific grid profile, select and apply a grid profile to the devices.
(Systems in Hawaii and systems with Enphase Batteries require you to set a profile.)
e. When prompted to start a device scan, tap OK.
The Device Communications LED
devices you installed are communicating or solid amber if any devices are not communicating.
17
lights solid green when all of the
flashes green while scanning. It lights solid green when all of the
© 2017 Enphase Energy Inc.
IQ Envoy Installation and Operation
Connecting to IQ Envoy with a
Mobile Device:
The Envoy's AP (Access Point)
Wi-Fi network allows you to
connect your mobile device to
the IQ Envoy. The AP Mode
LED lights solid green when
the network is available.
• On the IQ Envoy, if the AP
Mode LED is not lit,
press the AP Mode button.
• On your mobile device, go
to Settings and join the Wi-
Fi network "Envoy_nnnnnn"
(where "nnnnnn" represents
the final six digits of the
Envoy serial number).
141-00039 Rev 01