Table of Contents
Advertisement
Chapter 4. Guide for raised floor preparation
This chapter provides recommendations and requirements for making the necessary openings in the
raised floor for installation.
The drawings on the following pages are intended only to show relative positions and accurate
dimensions of floor cutouts. They are not machine templates and are not drawn to scale.
Raised floor cutouts should be protected by electrically non conductive molding, appropriately sized,
with edges treated to prevent cable damage and to prevent casters from rolling into the floor cutouts.
|
Note: For a water-cooled model on a raised floor, the height of the raised floor (subfloor to top surface of
floor tile) must be a minimum of 228.6 mm 9 inches) to accommodate the bend radius of the water hoses.
|
© Copyright IBM Corp. 2012, 2014
Level 01f
59
Advertisement
Table of Contents
