Lens Port Options; 5516.15 Dome Port (Included With Housing) - Ikelite 6970.03 Instruction Manual

3. Make sure no controls or wires are interfering with the o-ring or the
back of the housing.
4. Place each lid snap into the corresponding hook on the housing
back.
5. Push the lid snaps towards the housing until they are flat against
the housing and the lock has engaged. Close opposing lid snaps at
the same time.
Even Gap on
All Sides
Lid Snap
6. Check the o-ring seal. The o-ring should form a uniform, solid line
around the back of the housing. There will be a small, even gap
around the housing between the housing back and the housing
front.

Lens Port Options

5516.15 Dome Port (included with housing)

NOTE: This housing is compatible with DLM Port Systems ONLY.
Housing is NOT compatible with FL and DL Lens Port Systems.
Lid Hook
Main O-ring
Housing Back
11