Default Configuration; Dte-Dce Local Flow Control; Set Dcd Signal &C - Wavecom WMO1-G900 User Manual

Wavecom GSM Modem

7.8. Default configuration

Restores the configuration profile.
Application to GSM
GSM to application

7.9. DTE-DCE local flow control

This command is used to control the operation of local flow control
between the DTE and DCE.
* < DCE_by_DTE > :
* < DTE_by_DCE > :
Application to GSM
GSM to application
Application to GSM
GSM to application
Application to GSM
GSM to application
7.10. Set DCD signal
This commands controls the Data Carrier Detect (DCD) signal.
This confidential document is the property of WAVECOM and may not be copied or circulated without permission
ATZ
OK
AT+IFC=<DCE_by_DTE>,<DTE_by_DCE>
0 none
1 Xon/Xoff local circuit 103
2 RTS
3 Xon/Xoff global on circuit 103 not supported
0 none
1 Xon/Xoff circuit 104
2 CTS
AT+IFC?
+IFC: 2,2
OK
AT+IFC=?
+IFC: (0-3),(0-2)
OK
AT+IFC=0,0
OK
&C
Z
command valid
+IFC
not supported
not supported
supported
not supported
not supported
supported
current values
possible values.
new values
48