WMOi3 Integrated Modem figure 2 : mechanical description II 4 screw holes allow the WMOi3 to be fixed on the mother PCB. The WMOi3 can be mounted indifferently on both sides (top or bottom). For further details see mechanical specifications in annex.
4.1.4 ON / ~OFF This input is used to switch ON or OFF the WMOi3 modem. A high level signal has to be provided on the ON/~OFF pin to switch on the modem. The level of the voltage of this signal has to be maintained to VCC during a minimum time of 1 second.
WMOi3 Integrated Modem 4.1.6 Reset signal (~RST) This signal is used to force a reset of the WMOi3. It has to be used by providing low level during approximately 2ms. This signal has to be considered as an emergency reset only. A reset procedure is already driven by an internal hardware during the power-up sequence.
Need help?
Do you have a question about the WMOi3 and is the answer not in the manual?
Questions and answers