Air Cleaner Inspection And Replacement; Lubrication - Ezgo REFRESHER 1200 Owner's Manual

OPERATION AND SERVICE INFORMATION
Read all of Manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
Drain Plug
Fig. 35 Add, Check and Drain Rear Axle Lubricant
Ratchet, 3/8" drive ....................................................... 1
Funnel ......................................................................... 1
Clean the area around the check and fill plugs. Remove
the check plug. The correct lubricant level is just below
the bottom of the threaded hole (Ref Fig. 35 on page 26).
If lubricant is to be added, remove the fill plug and add
lubricant using a funnel. Add lubricant slowly until lubri-
cant starts to seep from the check plug hole. Install the
check plug and the fill plug. In the event that the lubricant
is to be replaced, a drain plug is provided at the bottom of
the differential housing.
AIR CLEANER INSPECTION AND
REPLACEMENT
The air cleaner unit on the vehicle is a dry unit. Do not use oil
on the filter element or any part of the unit. To aide installation
and sealing, petroleum jelly may be applied to back side of
cover tabs and each side of filter seal.
Page 26
Fill / Check Plug
Owner's Manual and Service Guide
Cleaning the Air Filter Element
Do not use compressed air to clean the air filter;
doing so will damage the filter which may result in
damage to the engine.
The air cleaner element is accessible by unsnapping the
clips on the air canister and removing the cover and air
filter element (Ref Fig. 36 on page 26). Clean inside of
cover, canister and dust collector. Install the element and
cover the same way they were removed. Be sure the
positioning arrow on cover is pointing upward and all
clips are fastened securely.
Cartucho del
filtro de aire
Ref Air 2
Fig. 36 Air Cleaner
If the element is in acceptable condition, loose dirt may
be removed by tapping the filter lightly. Do not use oil on
the filter element or any part of the unit.

LUBRICATION

Do not use more than three (3) pumps of grease in
any grease fitting at any one time. Excess grease
may cause grease seals to fail or grease migration
into areas that could damage components.
Putting more than three pumps of grease in a grease fit-
ting could damage grease seals and cause premature
bearing failure (Ref Fig. 37 on page 27).
Elemento del
filtro de aire
Recogedor
Tapa del
de polvo
filtro de aire