Wheel Installation; Light Bulb Replacement; Fuse Replacement - Ezgo REFRESHER 1200 Owner's Manual

OPERATION AND SERVICE INFORMATION
Read all of Manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
removed from the wheel.
If the tire is flat, remove the wheel and inflate the tire to
the maximum recommended pressure for the tire.
Immerse the tire in water to locate the leak and mark with
chalk. Insert tire plug in accordance with manufacturer's
instructions.
To reduce the possibility of severe injury,
be sure mounting/demounting machine is
anchored to floor. Wear OSHA approved
safety equipment when mounting/demount-
ing tires.
If the tire is to be removed or mounted, the tire changing
machine manufacturer's recommendations must be fol-
lowed in order to reduce possibility of severe injury.

Wheel Installation

To reduce the possibility of component damage, do
not tighten lug nuts to more than 85 ft. lbs. (115 Nm)
torque.
It is important to follow the 'cross sequence' pattern when
installing lug nuts. This will assure even seating of the wheel
against the hub.
With the valve stem to the outside, mount the wheel onto
the hub with lug nuts. Finger tighten lug nuts in a 'cross
sequence' pattern (Ref Fig. 15 on page 14) . Tighten lug
nuts to 50 - 85 ft. lbs. (70 - 115 Nm) torque in 20 ft. lbs.
(30 Nm) increments following the 'cross sequence' pat-
tern.

LIGHT BULB REPLACEMENT

To reduce the possibility of premature bulb failure,
do not touch new bulbs with bare fingers. Use clean,
dry tissue or paper towel to handle the glass portion
of the bulb.
Page 14
El estilo del
neumático
puede variar
Ref Whi 1
For vehicles with headlights mounted in cowl, locate the
two screws on backside of cowl that secure headlight
(Ref Fig. 16 on page 14). Remove screws, pull headlight
out and disconnect wires. Connect wires to new head-
light, install in cowl and secure with screws previously
removed.
Headlight
Ref Hdr 2
Fig. 16 Headlight and Turn Signal Bulb Replacement
To replace the turn signal light bulb, support turn signal
housing from backside of cowl while removing two
screws securing lens. Install new bulb and replace lens.
To replace the tail and brake light bulb, roll the rubber
bezel from around the edge of the taillight and remove
lens. Install replacement bulb and replace lens.

FUSE REPLACEMENT

To replace fuses, locate the fuse block under the driver
side seat. Pull out old fuse and replace with a new auto-
motive type fuse. Headlight and taillight bulbs and fuses
are available from a local Distributor, an authorized
Branch or the Service Parts Department.
Owner's Manual and Service Guide
Fig. 15 Wheel Installation
Turn Signal Lens
Bulb
'Secuencia cruzada'
1 3
2
4
Inside
of Cowl
Turn Signal
Housing