GRAPHTEC FCX2000 SERIES Setup Manual page 17

18
Enter the registered "Email" and "Password" and then
click on the [Sign In].
19
The screen indicating that it is in the sign-in will be
displayed.
This concludes the installation of [Cutting Master 4].
Model selection method of "Cutting Master 4"
1
Double-click on the "Cutting Master 4" icon that has been
created on the desktop.
2
Select the model to be used and click on the [Next].
3
Check the "Device setting name" and click on the [Next].
4
Select the connection method to be used and click on
the [OK].
* The port to be used must have been previously
connected to the FCX2000.
5
Check the "Device setting" and click on the [OK].
Now, the model selection of the "Cutting Master 4" is
complete.
17