GRAPHTEC FCX2000 SERIES Setup Manual page 15

D. Install User's Manual
Follow the below procedures to install the FCX2000 User's
Manual (pdf format).
Adobe Reader must be installed on your computer in order to
read the manual.
Installing "User's Manual"
1
Click on [Install User's Manual].
The"FCX2000 User's Manual Setup" screen will appear
momentarily.
Click on [Next].
•
Setup in a Macintosh operating environment
A. Set Up Cutting Master 4
Cutting Master 4 is a plug-in driver that can output directly to
the cutting plotter from Adobe Illustrator.
Installing "Cutting Master 4"
* The computer to be installed must be connected to the
Internet.
* Email address for the account registration is required.
1
Set up the "USER GUIDE & SOFTWARE DVD" in the
computer.
2
Open "Cutting Master 4" folder in the DVD and double-
click on the "Cutting Master 4_signed.pkg" file.
Install it in accordance with the wizard from here.
3
The following screen may be displayed.
Click on the [OK].
2
When this screen appears, click on [Finish].
This concludes the installation of the [User's Manual].
The newly-installed [User's Manual] will be registered under
your Windows Start Menu.
4
Click on the [Continue].
5
Enter the "User name" with the administrator privileges
and "Password" and click on the Install Software.
6
Enter the "User name" with the administrator privileges
and "Password" and click on the [OK].
15