Password Lost - What To Do - Siemens SENTRON PAC3100 Manual

Parameterizing
9.2 Parameterizing the operator interface
4. Change the password with:
F2
5. Accept the new password with:
F4
The password is permanently saved.
The display returns to display mode.
Initial situation: Password protection switched on:
If password protection is switched on, the valid password must be entered in order to change
the password.
To change the password:
1. Call the "PASSWORD PROTECTION" display.
2. Go to the "PASSWORD" device setting:
F2
3. Open edit mode of the "PASSWORD" device setting:
F4
4. The device opens the "ENTER PASSWORD" dialog box.
5. Enter the password and confirm with
F4
If you have entered the correct password, the password becomes visible in the
PASSWORD field.
6. Open edit mode of the device setting "PASSWORD" with:
F4
7. Change the password with:
F2
8. Accept the new password with:
F4
The password is permanently saved and becomes effective immediately.
The display returns to display mode.
The newly assigned password remains visible until you exit the dialog box with F1
9.2.11.5

Password lost - what to do?

If you have forgotten the password, please contact Technical Assistance. You will receive a
new password from them.
You can find the address of Technical Assistance in the Chapter "Introduction".
Requesting a new password
Have the serial number of the device ready when making telephone enquiries or include the
serial number in written enquiries.
The serial number is printed on the device housing and is specified in "SETTINGS
> DEVICE INFORMATION".
98
and F3
or F3
and F3
SENTRON PAC3100
Manual, 07/2009, A5E02385159B-01
.