Parameterizing The Device; Setting The Language; Figure 7-1 Language Selection - Siemens SENTRON PAC3100 Manual

7.3

Parameterizing the device

Procedure
To start up the device, you must specify the operating parameters listed below in the device
settings:
● Connection type
● Voltage
– Direct measurement on the system or using voltage transformers
– Measuring input voltage in the case of direct measurement on the system
– Primary and secondary voltage when measuring using voltage transformers
● Current
– Primary current
When using the RS 485 interface:
● Communication settings
The following settings are also useful:
● Language
● Phase labels
● Password protection
See also
Password management (Page 95)
7.3.1

Setting the language

First, set the language in which the display text is to appear.
The available languages are displayed:
● at initial startup,
● after resetting to factory settings
English is the default language.
Figure 7-1
SENTRON PAC3100
Manual, 07/2009, A5E02385159B-01
Language selection
Commissioning
7.3 Parameterizing the device
53