Installing A Wilson Outside Antenna - Wilson Electronics SIGNALBOOST MINI-AMP Installation Manual

Installing a Wilson Outside Antenna

To receive the best cell signal, select a location in the center of the vehicle's roof 12 inches
away from any other antennas and free of obstructions.
Follow the specifi c antenna installation instructions included with the outside antenna (sold
separately).
Carefully
Pull Down
Door Seal
Amplifier Instructions - SBoostMSec1:4 Sec1:4 Amplifier Instructions - SBoostMSec1:4 Sec1:4
The outside antenna must be installed
vertically. Signal performance will be
degraded if the antenna is not vertical.
Optional Magnet-
The antenna cable may be run through the
Mount Antenna
door to the amplifi er.
Shown
For a more professional-looking installation,
Run Cable
the antenna cable may be run under the
Under
door seal. Carefully pull down the door
Seal
seal. Run the cable through the seal
and push the seal back into place. This
prevents constant wear and tear on the
cable as the door opens and closes.
The antenna cable is small enough to easily
tuck under the door seal or plastic molding.
Tuck Cable
Under Seal
!
Warning: Do not use any type of glass-
mount antenna with this amplifi er. The outside
and inside antennas must be shielded from
each other to prevent oscillation.
!
Warning: The outside antenna must
have a separation of at least 10 inches from all
persons during normal operation.
4
4/2/2008 9:16:51 AM 4/2/2008 9:16:51 AM