Table of Contents
Advertisement
SOFTWARE SETUP
Configuring Ethernet
communications
NOTE:
NOTE
3–16
As indicated by the window, the "Quick Connect" feature can quickly connect the software
to a front port if the USB is selected in the interface drop-down list. Select " Relay" and
press the Connect button. Ethernet can also be used as the interface for Quick Connect as
shown above.
When connected, a new Site called "Quick Connect" will appear in the Site List window.
The Site Device has now been configured via the Quick Connect feature for either USB or
Ethernet communications. Proceed to Connecting to the Relay below, to begin
communications.
Before starting, verify that the Ethernet cable is properly connected to the RJ-45 Ethernet
port.
The 339 relay supports a maximum of 3 TCP/IP sessions.
339 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 3: INTERFACES
Advertisement
Table of Contents
