Table of Contents
Advertisement
CHAPTER 2: INSTALLATION
Mounting
CAUTION:
CAUTION
339 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL
STANDARD PANEL MOUNT
The standard panel mount and cutout dimensions are illustrated below.
To avoid the potential for personal injury due to fire hazards, ensure the unit is
mounted in a safe location and/or within an appropriate enclosure.
Figure 3: Panel mounting
STEP 2
KEEP THE HANDLE IN ITS ROTATED
POSITION UNTIL THE DRAW-OUT UNIT
IS INSERTED COMPLETELY
NOTE: IT IS THE RESPONSIBILITY OF THE USER TO ENSURE THAT THE EQUIPMENT IS INSTALLED, OPERATED, AND USED FOR ITS
INTENDED FUNCTION, IN THE MANNER SPECIFIED BY THE MANUFACTURER. IF THIS IS NOT THE CASE, THEN THE SAFETY PROTECTION
PROVIDED BY THE EQUIPMENT MAY BE IMPAIRED.
MECHANICAL INSTALLATION
THE HANDLE MUST BE ROTATED 90
⁰
WHILE SLIDING THE 339 DRAW-OUT
UNIT INTO THE CAPTIVE UNIT
STEP 3
PUSH THE HANDLE DOWN AND TIGHTEN
THE SCREW UNTIL THE HANDLE IS PARALLEL
WITH THE FRONT PANEL SURFACE
STEP 1
2–3
Advertisement
Table of Contents
