Table of Contents
Advertisement
CHAPTER 3: INTERFACES
Printing setpoints and
actual values
339 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL
6.
For example, if the firmware revision is L2L01MA120.000 (Firmware Revision 1.20) and
the current setpoint file revision is 1.10, change the setpoint file revision to "1.2x".
7.
Enter any special comments about the setpoint file in the "Description" field.
8.
Select the desired firmware version from the "New File Version" field.
9.
When complete, click OK to convert the setpoint file to the desired revision. See
Loading Setpoints from a File below, for instructions on loading this setpoint file into
the 339.
The software allows the user to print partial or complete lists of setpoints and actual
values. Use the following procedure to print a list of setpoints:
1.
Select a previously saved setpoints file in the File pane or establish communications
with a device.
2.
From the main window, select the Offline > Export Settings File menu item.
3.
The Print/Export Options dialog box will appear. Select Settings in the upper section
and select either Include All Features (for a complete list) or Include Only Enabled
Features (for a list of only those features which are currently used) in the filtering
section and click OK.
SOFTWARE SETUP
3–23
Advertisement
Table of Contents
