Salt Refill Reminder; Rinse Aid - Miele PG 8080U Operating Instructions Manual

Commissioning

Salt refill reminder

 Fill the salt reservoir with dishwasher
salt for reactivation as soon as

Refill salt appears in the display (If it
appears during a program, wait until
the end of the program).
 Press the centre button to confirm.
The salt refill indicator will go out.
After the salt reservoir has been filled,
the salt refill message may still appear
in the display if the salt concentration
has not yet reached the correct level. If
this is the case, press the middle button
again.
The Refill salt message is turned off if
you have programmed the commercial
dishwasher to a water hardness below
4gr/gal (=0.7 mmol/l).

Immediately after refilling the salt
reservoir, run the Pre-wash or Short
program without a load in order to
remove any traces of salt from the
cabinet.
22

Rinse aid

Rinse aid is necessary to ensure water
does not cling and leave marks on
dishes and glassware during the drying
phase and helps dishes dry faster after
it after it has been washed.
Rinse aid is filled in the reservoir and
the set amount will be automatically
dispensed.

Fill the reservoir with rinse only.
Do not fill it with dish soap or
cleaning agent.
This would damage the rinse aid
reservoir.
Suitable products are available from
Miele Professional.
Alternatively, it is possible to use
household vinegar with a max. 5% acid
content or liquid citric acid with a max.
10% acid content. The resulting rinsing
and drying quality will not, however, be
as good as when rinse aid is used.

Do not use vinegar with a higher
acid content (e.g., vinegar essence
with 25% acid).
This would damage the commercial
dishwasher.